TC9493VMOI Rev AG 12/10 2009 Avery Dennison Corp. All Rights Reserved. MONARCH 9493™ VEHICLE MOUNT INSTRUCTIONS Using the vehicle mount, you can a
10 Using the External Supply Holder Use the optional external supply holder with larger supply rolls. Feed the supply through the printer using the fa
11 4. Align the holes in the supply holder with the posts on the mounting plate. The supply holder goes on the “outside” of the vehicle mount. 5. Re
12 Electrical Specifications Output is electrically isolated from the input. Output common is not connected to the forklift module chassis. It can be
2 Connecting Communications Cables The printer uses either 9-pin serial communications or USB communications. For best results, use only Monarch® cab
3 Replacing the Fuse The vehicle mount uses an NRTL listed 10-amp, 250-volt fast blow fuse (order part 128022). The fuse is located on the cable on
4 5. Plug the battery charging cable into the battery socket on the back of the printer. Reading the LEDs Three LEDs on the vehicle mount indicate th
5 Installing Overhead (Recommended) 1. Select a suitable location for the mount inside your vehicle. 2. If using the mounting plate, center the moun
6 Installing Vertically or on a Tabletop 1. Select a suitable location for the mount inside your vehicle. 2. If using the mounting plate, align the
7 Routing Electrical Cables Only qualified personnel should install the vehicle mount. When wiring the mount to your vehicle make sure you observe the
8 Wiring the Mount to Your Vehicle Vehicle battery version only. Follow these steps to wire the mount to the vehicle’s battery. 1. Connect the fuse h
9 Attaching the Printer To attach the printer on the vehicle mount: 1. Use the M3 allen wrench to remove the plastic strap buttons on each side of th
Commentaires sur ces manuels