TC9864CSQR Rev. AA 6/08 ©2008 Avery Dennison Corp All rights reserved. A64 CS Stacker Quick Reference This Quick Reference contains supply loading
2 Stacker Full Cable Power Cord6. Connect the stacker full cable and stacker communication cable between the stacker and your printer. 7. Plug the
3 5. Adjust the side bar guide: • The side bar is attached with magnets. • Align the side bar with the notch of the outer tag pusher. Make sure th
4 Setting the Flag Sensor The flag sensor is located on the bottom of the knife assembly and is used to cut tags with a printed flag mark. Note: When
5 Power On/Off 1. Turn on the circuit breaker, then turn on the power switch. Using the Control Panel The following table describes how to
6 About the Menu Overview The stacker has three mode menus shown below. Press the MODE key to navigate through the main menu and display each mode. Pr
7 Cleaning 1. Turn off the stacker. 2. Remove any tags. 3. Pull the black release block to open the knife assembly. 4. Use compressed air or a sm
8 Error Messages Error Messages are shown on the display and the ERROR light flashes. Press STOP/START to clear the error message and return to READY
Commentaires sur ces manuels