Avery Dennison Power Stacker Instructions d'exploitation télécharger pdf (Page 10)

5. Push

the knife toward the printer until the knife does not pivot or rotate.

3. Use the tab to lift the transport and see where the tags are inside the

stacker. If the tags are too close to either wall of the stacker, adjust the

knife alignment.

The supply is centered inside the printer but it may drift when it enters the

knife and the stacker. Sliding the knife to the left or right corrects the

alignment.

6. Slide the knife to the left or right to center the tags inside the stacker.

8. Feed another batch of tags through the knife and repeat steps 1-8 if

necessary.

4. Loosen the three thumbscrews connecting the knife to the printer.

Lift

Here

Tags too close to

wall of stacker

7. Tighte

n the three thumbscrews.

1-6 Operating Instructions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Avery Dennison Power Stacker Instructions d'exploitation Page 10