Avery-dennison 9450 RASCAL Addendum 3 Manuel d'utilisateur télécharger pdf

FAST CHARGER ADDENDUM

The Fast Charger is a battery charger for your printer's Nickel

Cadmium (NiCd) battery. It charges a battery within two hours after

initial charge, which may take longer depending on the state of the

battery. For optimum battery life, you must charge the battery when

the printer's LED/LCD indicates the battery is low.

Generally, you will charge the battery 300 - 500 times over the life of

the battery. Partially charging the battery causes this variation.

When you're not using or charging the battery, it loses 2 - 3% of its

charge daily. Also, extremely hot environments increase the

discharge rate and extremely cold environments decrease the

discharge rate. The battery loses its charge quicker if you store it

attached to a printer.

The following diagram illustrates the major parts of the Fast Charger:

1 2 3 4 5

2Using the Fast ChargerTo charge a battery:1. Remove the battery from the printer.2. Plug the charger's connector into the socket on the battery

3Reading

4Using Your Ni-Cd Battery To prevent damaging or reducing the life of your printer's NickelCadmium (Ni-Cd) battery, read this document.Note: Be s

5Getting

Modèles reliés 9450 RASCAL Addendum 2

Pas de commentaire