Avery-dennison 9460IP Manuel d'utilisateur

MONARCH Sierra Sport and 9460 are trademarks of Paxar Americas, Inc. Paxar is a trademark of Paxar Corporation. Microsoft and Windows are either r

10 Preferred BSS AP ID is reserved for future use. If Preferred AP is set, the printer attempts to associate with the preferred Access Point. If tha

11 DHCP Configuration 1. Set the IP Address (Local) to all zeros on the Card Configuration screen. 2. Select the check box for “Enable DHCP.” 3.

12 6. Connect the printer’s radio harness to the printer’s serial port. 7. Turn on the printer. The IP printer is ready to use. NOTE: Do not chan

13 To check the printer’s radio configuration, print test labels. Press the A button under the T icon to enter the diagnostics program. Tool Box is

14 ♦ The recommended temperature for charging is 68°F (20°C) to 77°F (25°C). The operating temperature for the battery is the same as for the printe

15 Troubleshooting Use the following table to correct some minor problems that may occur. Problem Action Printer does not connect to a network (peer

16 Printer Specifications Height: 6.6 inches (168 mm) Width: 3.6 inches (91 mm) Depth: 4.8 inches (122 mm) Weight: 1.9 pounds (.86 kg) Shipping We

2 Selecting the Printer Using a Serial Interface Before you can use the IP printer, you must configure it. All nodes of a wireless network need to ha

3 5. Click Configure Interface. 6. Make sure you select the correct communication port and 19.2 Baud Rate (19.2 is the only supported baud rate). 7.

4 9. Highlight the printer to configure and click Config. A CAUTION window appears. Read all the information. You can disable the CAUTION window

5 5. If necessary, click Configure Interface to check the network devices available on the host. 6. Make any changes and click Ok when finished or c

6 Configuring the RF Interface Setting a Name and ESS ID 1. Enter a Unit Name. Use a meaningful name, for example, WHSEFLR. 2. Enter the 802.11(b)

7 Setting the Power Save Mode 1. Select the Power Save mode by checking the Enable box from the Card Configuration screen. 2. Set the Algorithm to

8 Setting WEP Options WEP is not available for 802.11 radios. 1. To set WEP options, click Extended Configuration from the Card Configuration screen.

9 Setting Ad Hoc Mode Ad Hoc mode is not available for 802.11 radios. 1. Select the Ad Hoc Mode by checking the Enable box. 2. Select the Override