Avery Dennison ALX 92x Manuel d'utilisateur

06/06 Rev. 3.05-01 OPERATING MANUALALX 92xSetupWinding pattern ...2Selecting the printing material ...

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x10 14.Thread the backing paper around dancer arm [12A] and deflection roller as illus-trated [12]. 15.

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x11Inserting ribbon¯ Skip this section if you intend to print directly onto thermal material.P For in

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x12Inserting a new ribbon roll 1. Open the hood. 2. Put the ribbon roll on the lower right ribbon mandr

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x13SettingsRibbon tensionTo achieve an optimal print result, the ribbon has to run without creases. Thi

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x14Label sensorThe ALX92x is equipped with a light trans-mission sensor for punch recognition:Setting t

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x15Adjustment button for printhead pressureThe material width and / or material thickness influence the

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x16Dispensing edgeBy inclining the dispensing edge, the dispensing position can be fine adjusted withou

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x17Material ParametersUsing the following parameters, you can tell the device which kind of labelling m

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x18IndexBBackcoating 5Braking torque, ribbon 13DDirect thermal printing 4HHexagonal plastic bolt, red 1

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x2Winding patternThe winding diagram shows the winding direction of material and ribbon through the ALX

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x3Names of partsNo. Name No. Name1 Adjustment knob for printhead pressure13 Feed roller2 Ribbon rewindi

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x4Selecting the printing materialThermal transfer / direct thermal printingThe ALX92x can print onto la

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x5Thermal transfer ribbonThe following is recommended for thermal transfer ribbons:• The back of the ri

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x6Inserting label materialRemoving spent backing paperThe backing paper rewinder can exactly rewind the

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x7Inserting a new label roll 1. Turn thumb screw [3A] loose and swivel guide rod [3B] aside. 2. Push th

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x8 5. Open the front cover. 6. Set the material guide to the width of the label material. To do this lo

06/06 Rev. 3.05-01 OPERATING MANUAL SetupALX 92x9 9. Peel labels off the backing paper for a stretch of appr. 50cm [8]. 10.Open the pressure roller le